Is smoke normal for starting a new mariner 3.5hp ?

All topics related to owning your own boat here.
Post Reply
Johnn
Member
Member
Posts: 30
Joined: Sat Oct 31, 2009 12:00 am

Is smoke normal for starting a new mariner 3.5hp ?

Post by Johnn »

First time I pulled, it started and had a constant flow of water coming out, though did get abit smokey!, Is this because there wasent alot of petrol in there?, I only had it going about 30 secs-1min,
Thanks



rabbi2
Global Moderator
Global Moderator
Posts: 9460
Joined: Wed Sep 05, 2007 12:00 am
Location: Blackburn. Lancashire

Post by rabbi2 »

To strokes are normally smoky but you could have had the fuel mixture wrong (too much oil in the pertol) Better this than too little. On the other hand it could be old fuel.
Cheers
keith :D :D

tomcat
Regular
Regular
Posts: 357
Joined: Fri Oct 24, 2008 12:00 am
Location: Ribble Valley, Lancashire.

Post by tomcat »

If it's a two stroke, the run in period usually runs an oil rich mixture for the first ten hours and runs somewhat smokey.
The other fact that can create smoke is, if the engine is new or has been winterised the internals of the cylinder will have been given a good dose of rust inhibitting oil. This is burned off in the first 10-20 minutes running. Another fact to consider is, is everything you are referring to as smoke, in fact smoke? Modern outboards have water cooled exhaust systems resulting in water vapour exiting the exhaust port in addition to exhaust gasses.
If the excessive, (some is normal) smoke continues after an hours running, it may require further investigation.
Hope this assists, George.

hammyloz
Regular
Regular
Posts: 268
Joined: Wed Mar 26, 2008 12:00 am
Location: eastbourne e/sussex

Post by hammyloz »

in response to the 2 answers you have it is either too much oil or steam or even worn rings

Post Reply